• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 3-9. Compressor and engine assembly, model BMW-452-ENG, removal points.
Section VII. ENGINE ELECTRICAL SYSTEM

TM-5-4310-227-15 Compressor Reciprocating: Air; Gasoline Engine 15 CFM 175 PSI; Receiver Mounted (Champion Pneumatic Model OEG-458-ENG-1) Manual
Page Navigation
  55    56    57    58    59  60  61    62    63    64    65  
TM 5-4310-227-15
19 Bushing
10  Bracket
1
Link
20 Tee-to-unloader valve tube
11  Unloader valve
2
Screw
21 Through bolt
12  Pipe clamp
3
Screw
22 Mounting bracket
13  Pipe nipple
4
Governor control
23 Bracket
14  Screw
5
Screw
24 Stop
15  Check valve
6
Starter
25 Spring
16  Pipe nipple
7
Cable
26 Engine
17  Pipe tee
8
Strap
27 Governor control lever
18  Flexible tube
9
Screw
Figures 3-10. Starter, governor control, air lines and fittings, models BMW-452-ENG
and BMW-452-ENG-1, removal points.
3-42. Idling Device
c. Installation (Models BMW-452-ENG
and BMW-452-ENG-1).
a. Removal (Model BMW-452-ENG-1).
(1) Position a new gasket and the fuel
(1) Disconnect the tube (8, fig. 3-7) from
pump (43 ) on the cylinder and crank-
the cock (7).
case assembly (18) and secure with
(2) Remove the screws (4) and nuts that
the screws (19) and lockwashers.
secure the idling device (3) to the
(2) Connect the fuel pump-to-carburetor
m o u n t i n g bracket (6) and remove
tube (9, fig. 2-7 ) and fuel strainer-
the idling device.
to-fuel pump tube (41) to the fuel
(3) Remove the bolt and lockwasher that
pump (43).
secures the mounting bracket (6) to
the intake manifold (5) and remove
(3) Open the fuel shutoff valve (18, fig.
the mounting bracket.
2-6).
3-33






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.