g. Unit of Measure (U/M). Indicates the standard of the basic
quantity of the listed item as used in performing the actual mainten-
ance function. This measure is expressed by a two-character alphabet-
ical abbreviation (e.g. , ea, in, pr, etc). When the unit of measure
differs from the unit of issue, the lowest unit of issue that will
satisfy the required units of measure will be requisitioned.
h. Quantity Incorporated in Unit. Indicates the quantity of the
item used in the breakout shown on the illustration figure, which is
prepared for functional group, subfunctional group, or an assembly. A
"V" appearing in this column in lieu of a quantity indicates that no
specific quantity is applicable, (e.g., shims, spacers, etc).
a. Usable on codes are shown in the description column. Uncoded
items are applicable to all models. Identification of the usable
codes used in this publication are:
Serial No. Range
Uncoded items are applicable to all serial number ranges.
b. Bulk material required to manufacture items are listed in the
Bulk Material Group of this manual.
c. Detailed assembly instructions for items source coded to be
assembled are found in TM 5-4310-350-14. Assembly components are
listed immediately following the item to be assembled.
d. Repair parts kits and gasket sets appear as the last entries in
the repair parts listing for the figure in which its parts are listed
as repair parts.
e. The following publications pertain to the air compressor and
TM 5-4310-350-14 Operator, Organizational, Direct Support and
General Support Maintenance Manual for Compres-
sor, Model Nos. HR5-8M-3 and HR5-8M-4,
LO 5-4310-350-12 Lubrication
Order for Compressor,
f. In the parts list, some items are indented to show that they
are a component or components of the item under which they are inden-