TM 5-4310-352-14
APPENDIX C
COMPONENTS OF END ITEMS LIST
SECTION I. INTRODUCTION
(2) Item Number. The number used to identify
C-1. SCOPE.
item called out in the illustration.
This appendix lists Integral Components of and Basic Issue
b. National Stock Number (NSN): Indicates the na-
Items (BII) for the Air Compressor to help you inventory
tional stock number assigned to the end item which will be
items required for safe and efficient operation.
used for requisitioning.
c. Part Number (P/N): Indicates the primary number
C-2. GENERAL.
used by the manufacturer which controls the design and
The components of end item list are divided into the fol-
characteristics of the item by means of its engineering
lowing sections:
drawings, specifications, standards and inspection re-
quirements to identify an item or range of items.
These items, when assembled, comprise the Air Compres-
d. Description: Indicates the federal item name and,
sor and must accompany it whenever it is transferred or
if required, a minimum description to identify the item.
turned in. These illustrations will help you identify these
e. Location: The physical location of each item
items.
listed is given in this column. The lists are designed to in-
ventory all items in one area of the major item before
mum essential items required to place the Air Compressor
moving on to an adjacent area.
in operation, to operate it and to perform emergency re-
f.
Usable on Code: (Not Applicable)
pairs. Although shipped separately packed, they must ac-
g. Quantity Required (Qty Read): This column lists
company the Air Compressor during operation and when-
the quantity of each item required for a complete major
ever it is transferred between accountable officers. The
item.
illustrations will assist you with hard-to-identify items. This
h. Quantity: This column is left blank for use during
manual is your authority to requisition replacement BII
inventory. Under the received column, list the quantity you
based on Table(s). of Organization and Equipment
actually receive on your major item. The date columns are
(TOE)/Modification Table of Organization and Equipment
for use when you inventory the major item at a later date,
(MTOE) authorization of the end item.
such as for shipment to an
C-3. EXPLANATION OF COLUMNS.
a. Illustration: This column is divided as follows:
(1) Figure Number. Indicates the figure number
of the illustration on which the item is shown (if applicable).
other site.
Change 1
C-1
