• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 4-25. Alternator assembly removal and installation.
Figure 4-26. Fuel injection nozzles, removal and installation.

TM-5-4310-354-14 Compressor Rotary; Air Skid Mounted; Diesel Engine 125 CFM 100 PSIG (Davey Model 6M125) Manual
Page Navigation
  106    107    108    109    110  111  112    113    114    115    116  
TM 5-4310-354-14
(2) Inspect brush and holder assembly for
WARNING
excessive wear, cracks, or any other
defect.
Dry cleaning solvent, P-D-680, used
to
clean
parts
is
potentially
(3) Inspect the drive belt and pulley for wear,
dangerous
to
personnel
and
cracks, or any other defect.
property.
Avoid  repeated  and
prolonged skin contact. Do not use
(4) Inspect attaching hardware for distortion,
near open flame or excessive heat.
cracks, damaged threads, or any other
Flash point of solvent is 100 F-130 F
defect.
(38 C-59 C).
c. Installation.  Install the alternator assembly as
b. Cleaning and Inspection.
shown in figure 4-25.  Adjust drive belt tension (figure
4-5) and connect the battery cable clamps to battery
(1) Clean  the  exterior  surfac es  of  the
terminals.
alternator assembly with a clean cloth
soaked with solvent, Federal Specification
4-39. Battery. Refer to figure 4-10 for battery and cable
P-D-680, Type II. Dry thoroughly. Blow
removal and installation.
dust and dirt from the inside of the
assembly with dry compressed air.
4-40. Battery Charging Receptacle.  Refer to figure
4-10 for battery charging receptacle removal and
installation. Refer to paragraph 4-22. b.(2) for cleaning
and inspection.
Section XVI. MAINTENANCE OF ENGINE FUEL SYSTEM, COOLING SYSTEM, INTAKE,
AND EXHAUST MANIFOLD GROUP
This  section  consists  of  the
4-41.
General.
NOTE
organizational level maintenance of the engine fuel
injection nozzles, fuel transfer pump, related fuel
As each injection nozzle and fuel line
injection lines, cooling fan, water pump assembly,
is  removed,  mark  or  tag  for
thermostat, temperature sending units and switches, the
installation  reference.
Injection
engine intake and exhaust manifolds.
nozzles and fuel lines should be
installed in the same location as
4-42. Engine Fuel Injection Nozzles.
removed.
a. Removal. Remove the fuel injection nozzles as
CAUTION
shown in figure 4-26.
Handle the fuel injection nozzles with
care at all times to prevent damage.
4-51






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.