• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 5-14. Pressure switch assembly. - TM-5-4310-358-140060
Appendix A. REFERENCES - TM-5-4310-358-140062

TM-5-4310-358-14 Compressor Air Reciprocating Electric Motor Driven Reciever Mounted 5 CFM at 175 PSI Model no. HR2-6M-2 Manual
Page Navigation
  52    53    54    55    56  57  58    59    60    61    62  
TM 5-4310-358-14
g. Turn on the outside power source to check the
NOTE
adjustment.  To check the CUT-IN pressure, open the
drain cock and allow air pressure to fall below 165 psi.
If the differential is increased only by
Close the drain cock, and the compressor should start
turning
the
differential
screw
immediately.
clockwise,  the  CUT-IN  pressure
changes only slightly, and the CUT-
h. Install the cover on the pressure switch.
OUT pressure rises.
Figure 5-15. Pressure switch adjusting and differential screws.
5-28






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.