TM 5-4310-360-14
Removal.
b.
4-28. Frame continued.
Jack up the axle end of the handtruck
(1)
(3)
Inspect all hardware for damaged
and block securely under the bumper
threads.
or rails.
(4)
Repair or replace all defective parts.
Release the air from the tires.
(2)
Remove cotter pins (2, figure 4-7),
(3)
Installation.
c.
nuts (1, figure 4-8), washers (7, figure
(1)
Attach feet (6, figure 4-7) with cap-
(3) and capscrews (4).
screws (4) and nuts (5).
Disassemble the wheel disc halves (5),
(4)
(2)
Assemble hubs (11, figure 4-8), roller
tubes (6) and tires (7).
bearings (10), bearing seals (9) and
end caps (8).
Disassemble end caps (8), bearing seals
(5)
(9), roller bearings (10) and hubs (11).
(3)
Assemble tires (7), tubes (6), wheel
disc halves (5), capscrews (4), hub
Remove axle (3, figure 4-7).
(6)
bolts (3), nuts (2), washers (7, figure
Cleaning and Inspection
c.
to axle with cotter pins (2, figure
WARNING: Drycleaning solvent, P-D-680,
kg/sq cm).
used to clean parts is potentially dangerous
to personnel and property. Avoid repeated
(4)
Attach air receiver tank to handtruck
and prolonged skin contact. Do not use near
with nuts and bolts.
open flame or excessive heat. Flash point of
solvent is 100oF (38C).
(5)
Attach fuel tank with brackets, hangers
(1)
Wash axle with cleaning solvent,
and nuts. Attach fuel line to fuel tank.
P-D-680, and dry thoroughly.
(2)
Inspect axle for cracks or bends.
(6)
Attach compressor to handtruck.
Replace axle if damaged beyond usage.
(7)
Attach aftercooler tube and intercooler
Installation.
d.
tube to compressor and air tank.
(1)
Install axle (3, figure 4-7) on
(8)
Place engine assembly on handtruck
handtruck.
and fasten. Do not tighten bolts at
this time.
(2)
Assemble hubs (11, figure 4-8), roller
bearings (10), bearing seals (9) and
(9)
Connect fuel line to fuel filter.
end caps (8).
(10) Install belts and adjust tension to
(3)
Install tubes (6), tires (7) and wheel
obtain belt deflection of 3/4 to 1 inch
disc halves (5).
midway between pulleys. Tighten
engine mounting bolts.
(4)
Install capscrews (4), hub bolts (3),
nuts (2), washers (7, figure 4-7), nuts
(1 1) Install belt guard.
(1, figure 4-8) and cotter pins (2,
Inflate the tires to 25 psi (1.766 kg/sq
5)
4-29. Axle.
cm).
General. The axle is a cylindrical steel rod
a.
6)
Remove the blocking and lower the
used to attach the wheel assemblies to the
jack.
handtruck assembly.
4-26
