TM 5-4310-367-14
COMPRESSOR DRIVE continued
REMARKS
ACTION
LOCATION/lTEM
4-20. INSTALLATION AND ADJUSTMENT continued.
To allow belts to be mounted on pulley.
Loosen.
4. 4 engine mounting
screws (6)
Slide in direction of air com-
5. Engine (7)
pressor.
Install.
6. 2 belts (8)
Belt tension is right when belts move 1/2 inch when pushed
Adjust position for proper
7. Motor (7)
on half way between pulley and flywheel.
belt tension.
CAUTION
Too little belt tension causes
belts to overheat and wear
out prematurely. Too much
tension causes bearing wear
in motor and compressor.
Tighten when proper belt
8. Engine mounting screws
tension is achieved.
(6)
nstall with four screws (9).
4-19
