• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TIGHTENING OF INFLATOR GAGE HOSE CONNECTIONS.
Chapter 4. ORGANIZATIONAL MAINTENANCE - TM-5-4310-371-140028

TM-5-4310-371-14 Compressor Unit Reciprocating Electric 25 CFM 175 PSI (4310-01-090-5911) Manual
Page Navigation
  17    18    19    20    21  22  23    24    25    26    27  
TM 5-4310-371-14
a. Loosen slotted set screw, as shown in figure 3-8 and remove air inlet filter assembly.
b. Open air inlet filter housing by removing housing screw and nut shown in figure 3-8.
c. Remove foam filters and wash in warm water with ordinary soap.
CAUTION
Do not use any caustic cleaners as they may damage the foam filters.
d. If filters will not get clean, become brittle or damaged, replace them.
e. When filters are clean, remove excess water by using low pressure compressed air.
f. Install filters into housing and screw housing back together.
g. Place air inlet filters assembly back in intake manifold and tighten down the slotted set screw until muffler is secured
firmly.
TM 5-4310-371-14/3-8
FIGURE 3-8. AIR INLET FILTER REPLACEMENT
3-12






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.