• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
EXCESSIVE OIL CONSUMPTION - TM-5-4310-371-140033
STARTER SWITCH - MOTOR DISCONNECT. - TM-5-4310-371-140035

TM-5-4310-371-14 Compressor Unit Reciprocating Electric 25 CFM 175 PSI (4310-01-090-5911) Manual
Page Navigation
  24    25    26    27    28  29  30    31    32    33    34  
TM 5-4310-371-14
TABLE 4-1. ORGANIZATIONAL TROUBLESHOOTING (Cont'd)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WARNING
Disconnect compressor unit from main power supply before servicing, replacing
or repairing parts of equipment, to avoid personal injury.
Step 1.
If compressor pump over-heats (hot to the touch of hand) shut
compressor unit off.
Allow compressor pump to cool until it is cool to touch
of the hand.
Step 2.
Check V belts to see if they are too loose or too tight.
Adjust as described in Chapter 3, Section III,
paragraph 3-3.
Step 3.
Check oil level to see if it is low.
If oil level is low, fill to correct level as described
in Chapter 3, Section I, paragraph 3-1.
Step 4.
Check oil to make sure correct weight oil is being used.
If improper oil weight is found, change oil as described
in Chapter 3, Section I, paragraph 3-1.
Section III. MAINTENANCE PROCEDURES
4-5. V BELT REPLACEMENT.
WARNING
Disconnect compressor unit from main power supply before servicing, replacing
or repairing parts of equipment, to avoid personal injury.
a. Loosen belt guard fasteners. (Figure 4-2)
b. Remove belt guard front. (Figure 4-2)
c. Loosen motor mounting nuts and move motor towards compressor pump until V belts can be removed easily.
(Figure 4-2)
4-7






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.