TM 5-4310-371-14
(b) Remove governor housing cover (figure 5-8, item 9).
(c) Remove governor cover gasket (figure 5-8, item 10).
(d) Remove spring sleeve (figure 5-8, item 11).
(e) Remove governor main spring (figure 5-8, item 12).
(f) Remove flat steel washer (figure 5-8, item 13).
(g) Remove hex steel cap screw (figure 5-8, item 14).
(h) Remove spring lockwasher (figure 5-8, item 15).
(j) Remove governor weight pins (figure 5-8, item 16).
(k) Remove governor weight (figure 5-8, item 17).
(l) Remove governor weight spindle (figure 5-8, item 18).
(3) Upper Governor Housing
(a) Remove hex steel cap screws (4) (figure 5-8, item 19).
(b) Remove governor baffle plate (figure 5-8, item 20).
(c) Remove upper governor housing (figure 5-8, item 21).
(d) Remove governor housing gasket set (figure 5-8, item 22).
b. Cleaning, Inspection, Repair or Replacement of Parts
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially dangerous to
personnel and property. Use in a well ventilated area as the fumes are dangerous
if inhaled. Avoid repeated and prolonged skin contact. Do not use near open
flame or excessive heat. Flash point of solvent is 100 F 138 F (38 C 59 C).
(1) All parts to be thoroughly cleaned with P-D-680 solvent, and then air dried.
(2) Inspect all parts for cracks, breaks, fissures, scores, distortions or any other damage.
(3) Repair or replace any damaged parts.
c. Reassembly
(1) Upper Governor Housing
5-29
