• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
COMPRESSOR CRANKSHAFT, BUSHING AND OIL SEAL
COMPRESSOR CRANKSHAFT, BUSHING AND OIL SEAL - Continued

TM-5-4310-376-14 Compressor Reciprocating Gasoline Engine Driven 15 CFM 175 PSI Model 50-6840 Manual
Page Navigation
  135    136    137    138    139  140  141    142    143    144    145  
TM 5-4310-376-14
5-8. COMPRESSOR CRANKSHAFT, BUSHING AND OIL SEAL - Continued
REMARKS
ACTION
LOCATION/lTEM
1 . Crankshaft, c. Force into position by tapping it (be care-
ful to strike center of shaft since an off
bushing and
center blow may spring it) with a lead
oil seal
hammer.
(cont'd)
d. Drive in assembly until snap ring groove in
outer bearing clears the end of the frame
about 1/16 inch (1.59mm).
e. Install snap ring by putting one end in the
groove and springing the ring into place.
f. Tap crankshaft back until snap ring is
tight against frame.
g. Inspect flywheel end of crankshaft; make
certain that there are no burrs and that
edges of the keyway are smooth and slightly
rounded to prevent damage to the oil seal (5).
h. Install new oil seal(s) with the sealing lip fac-
ing toward the inside of the crankshaft; coat
5-20






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.