3-14. DRIVE BELTS - Continued.
(1) Wash the belts in a mild solution of soap (Appendix E, item 5).
2) Rinse thoroughly with clean water.
(3) Allow to dry.
c. Inspection. Inspect the belts for damage.
d. Replace. Replace defective drive belts.
Figure 3-14. Drive Belts, Installation.
(1) Install belts (1) into position.
(2) Move motor (2) until the belt deflection at the mid-point between the pulleys is 3/8 to 1/2 inch.
(3) Tighten the four nuts (3) on the motor holddown bolts.
END OF TASK