TM 5-4310-379-14
3-46. Controls and Indicators (Cont).
(2)
Oil pressure gage. (figure 3-64).
(a)
Loosen fitting nut (1) and disconnect oil line (2).
(b)
Loosen fitting nut (3) and disconnect oil line (2) and remove.
(c)
Remove two nuts (4), washers (5), and bracket (6) and remove oil pressure gage (7).
(d)
Remove elbow (8).
NOTE
Leave 1 1/2 threads exposed when applying teflon tape. Wrap teflon tape in the direction that will not
unwrap as fitting is tightened. Failure to wrap teflon tape properly or having it extend past the end of the
fitting may cause a blockage in the oil distribution system.
(e)
Apply teflon tape to threads on oil pressure gage (7).
(f)
Install elbow (8) on gage (7).
(g)
Install gage (7) and secure with bracket (6), two washers (5) and nuts (4).
(h)
Install oil line (2) and tighten fitting nuts (1) and (3).
3-144
