• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CHAPTER 4 DIRECT SUPPORT MAINTENANCE
Table 4-1.  Direct Support Troubleshooting Procedures (Cont).

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
  211    212    213    214    215  216  217    218    219    220    221  
TM 5-4310-379-14 4-5. Direct  Support  Troubleshooting  Procedures .    Table  4-1  lists  the  common  malfunctions  that  may  be  found during  operation.    Refer  to  symptom  index  to  locate  the  troubleshooting  procedures  for  the  malfunction.    This  manual cannot  list  all  malfunctions  that  may  occur,  nor  all  test  or  inspections  and  corrective  actions.    If  a  malfunction  is  not corrected by listed corrective actions, notify your supervisor. SYMPTOM INDEX Symptom Page 1. Engine will not start..................................................................................................................................... 4-2 2. Engine runs rough or erratically................................................................................................................... 4-2 3. Engine overheats........................................................................................................................................ 4-3 4. Low pressure output pressure..................................................................................................................... 4-3 5. Power take-off will not engage.................................................................................................................... 4-3 Table 4-1.  Direct Support Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 1. ENGINE WILL NOT START. Check fuel injectors. Replace defective fuel injector (para. 4-10). 2. ENGINE RUNS ROUGH OR ERRATICALLY. Step 1.  Governor out of adjustment. Adjust governor (para. 4-11). Step 2.  Valve operating mechanism out of adjustment. Adjust valve operating mechanism (para. 4-21). Step 3.  Fuel injectors out of timing. Adjust fuel injectors (para. 4-10). Step 4.  Injector controls out of adjustment. Adjust injector controls (para. 4-9). 4-2







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.