• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CHAPTER 5 GENERAL SUPPORT MAINTENANCE INSTRUCTIONS - TM-5-4310-379-14_395
Table 5-1.  General Support Troubleshooting Procedures.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
  372    373    374    375    376  377  378    379    380    381    382  
TM 5-4310-379-14 5-5.    General  Support  Troubleshooting  Procedures.   Table  5-1  lists  the  common  malfunctions  that  may  be  found during  operation.    Refer  to  symptom  index  to  locate  the  troubleshooting  procedures  for  the  malfunction.    This  manual cannot  list  all  malfunctions  that  may  occur,  nor  all  test  or  inspections  and  corrective  actions.    If  a  malfunction  is  not corrected by listed corrective actions, notify your supervisor. SYMPTOM INDEX Symptom Page 1. Low compressor oil pressure.................................................................................................................... 5-2 2. Low compressor output pressure.............................................................................................................. 5-2 3. Compressor knocking.............................................................................................................................. 5-3 4. Compressor oil in discharge air................................................................................................................ 5-3 Table 5-1.  General Support Troubleshooting Procedures. Malfunction Test or Inspection Corrective Action 1 LOW COMPRESSOR OIL PRESSURE. Step 1. Check oil pump. Replace a defective oil pump (para. 5-35). Step 2. Check intercooler Replace a damaged intercooler (para. 5-27). Step 3. Check oil screen. Clean oil screen with solvent and dry with compressed air. 2. LOW COMPRESSOR OUTPUT PRESSURE. Step 1. Check intake valves. Replace or repair defective valves (para. 5-30). Step 2. Check discharge valves. Replace or repair defective valves (para. 5-30). Step 3. Check unloader valves. Replace or repair defective valves (para. 5-28). Step 4. Check cylinder head gasket for leaks. Replace cylinder head (para. 5-29) 5-2 Change 1







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.