3-17. PULLEY DRIVE - Continued.
(1) Remove two setscrews (1) attaching bushing (2) to pulley (3).
Bushing may need to be pried loose from shaft with a screw driver.
(2) Install setscrew (1) into middle hole of bushing (2) and jack bushing away from engine shaft.
(3) Remove bushing (2) and pulley (3).
Figure 3-7. Pulley Drive, Removal.
(1) Remove all build up of belt debris, dirt and oil, from pulley.
DO NOT breathe cleaning solvent vapors for long periods of time or use solvent
near open flames. To avoid illness, explosion, or fire, only use solvent in well
ventilated areas away from open flames.