TM 5-4310-386-14
4-44. Alternator (Cont).
c. Replace. (figure 4-57)
(1)
Remove wire (1) from alternator (2).
(2)
Remove three nuts (3), lockwashers (4), tag and remove wires (5) from alternator (2).
(3)
Remove bolt (6), securing alternator (2) to clamping plate (7).
(4)
Remove nut (8), two washers (9),and bolt (10) and remove alternator (2).
(5)
Install alternator (2) and secure with bolt (10), two washers (9),and nut (8) but do not fully tighten.
(6)
Ensure belts (11 ) are properly positioned.
(7)
Install bolt (6) but do not fully tighten.
(8)
Adjust belt tension so that a firm push midway between engine pulley (12) and blower pulley (13) will depress
belts (11) approximately 0.50 - 0.75 in. (1.27- 1.90 cm).
(9)
Tighten nut (8) and bolt (6).
(10)
Install wires (5) as tagged and secure with three nuts (3) and lockwashers (4)
(11)
Install wire (1) on alternator (2).
FOLLOW-ON MAINTENANCE
Install V-beltguard (para. 4-15).
4-140
