TM 5-4310-386-14
4-49. Oil Filter Assembly .
This task covers:
a.
Service
b.
Replace
INITIAL SETUP
Tools
Materials/Parts (Cont)
General Mechanic's Tool Kit
Solvent, Dry Cleaning (Item 24, Appendix E)
(NSN 5180-00-177-7033)
Rags, Wiping (Item 21, Appendix E)
Wrench, Torque (NSN 5120-00-910-3350)
Materials/Parts
Equipment Condition
Oil Filter Assembly
Compressor unit shut down (para. 2-13).
Gasket, Oil Filter Assembly
a. Service. (figure 4-66)
(1)
Place suitable container under oil filter drain and remove drain plug (1) and gasket (2).
(2)
Drain oil completely and replace drain plug (1) and gasket (2).
(3)
Remove screw (3), sealing ring (4), cover (5), gasket (6), and filter (7).
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to
personnel and property. Avoid repeated and prolonged skin contact. Do not use
near open flame or excessive heat. Flash point of solvent is 138°F (60°C).
(4)
Clean all items, except gasket and filter, with dry cleaning solvent and dry thoroughly.
(5)
Install filter (7) into cavity of engine (8).
(6)
Lightly lubricate gasket (6) with clean engine oil.
(7)
Install gasket (6), cover (5), sealing ring (4), and tighten screw (3). Torque screw to 25 - 26 lb-ft (34 - 35 Nm).
(8)
Remove oil filler cap (9).
(9)
Fill crankcase with oil to the top mark on dipstick (10).
(10)
Install oil filler cap (9).
4-156
