TM-5-4310-389-14
8
Place clutch release lever (holdback) spring (20) over end of release sleeve (24) and up against release
collar before installing links (28) to release sleeve (24).
9.
Place one release lever link (28) on each side of each hole on clutch release sleeve (24) with triangular
end of release lever link at release sleeve and point of triangle facing toward center of release sleeve.
10.
Attach lines to release sleeve with link pins (26) and retaining rings (29).
11.
Place the clutch release sleeve (24) with other parts assembled, down on clutch with each pair of release
links (28) astride release lever (27).
CAUTION
When installing pins, all pins must be installed with head leading rotation.
12.
Connect links to levers with pins (26) and retaining rings.
NOTE
Be sure retaining rings (29) are securely locked on pins (26).
13.
With the clutch release links (28) and release levers (27) connected, slide clutch release lever (holdback)
spring (20) over ends of release lever lines and into place on release levers (27).
14.
Insert the clutch facings (27 and 29) (three segments) in between the clutch body (53) and pressure plate
(49), and center.
15.
Lock clutch facings between the pressure plates as follows:
a)
With the clutch assembly resting on workbench, turn the clutch adjusting ring (43) counterclockwise
until pressure plate (48) almost contacts clutch facing (49).
b)
Place clutch driving ring over clutch facings with teeth in driving ring in mesh with teeth of clutch
facings, and locate the driving ring centrally relative to the pressure plate and clutch body.
NOTE
If driving ring is not properly located relative to pressure plate and clutch body, the clutch cannot be
assembled on the flywheel as the teeth of clutch facings will not enter the teeth of driving ring even
though the clutch drive shaft enters the pilot bearing.
4-104
