TM 5-4310-451-14
5-66. LOAD SOLENOID MAINTENANCE (Con’t).
3.
Remove four nuts (10), lockwashers (11), screws (4), and load solenoid (3) from bracket (12). Discard
lockwashers.
4.
Remove three screws (6), lockwashers (7), and bracket (12) from governor (9). Discard lockwashers.
b. DISASSEMBLY
1.
Remove spring (5) from bracket (14).
NOTE
Measure distance rear nut Is threaded on load solenoid to assist in Installing new load
solenoid.
2.
Remove two nuts (13) and bracket (14) from load solenoid (3).
c. ASSEMBLY
1.
Install rear nut (13) on load solenoid (3) same distance noted in disassembly.
2.
Install bracket (14) and second nut (13) on load solenoid (3).
3.
Install spring (5) on bracket (14).
d. INSTALLATION
1.
Install bracket (12) on governor (9) with three new lockwashers (7) and screws (6).
2.
Install load solenoid (3) on bracket (12) with four screws (4), new lockwashers (11), and nuts (10).
3.
Connect spring (5) to lever (8).
4.
Install three wires (2) on load solenoid (3) with two nuts (1).
TA7051 15
5-245
