TM 5-4310-451-14
5-99. OIL SEPARATOR AND FUEL TANK SUPPORT REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
áMaster battery switch in OFF position
áSix lockwashers
áFender-to-frame panels at front of rear tire and rear of
front tire removed (see paragraph 5-89)
Personnel Required: Two
Tools/Test Equipment:
áGeneral mechanic’s tool kit
a. REMOVAL
NOTE
Both oil separator and fuel tank
supports are removed same way.
This procedure covers one support.
1.
Place suitable supports under fuel tank.
2.
Support top of oil separator to lift bail.
3.
Have assistant support oil separator and fuel
tank support (3) and remove six nuts (4),
lockwashers (5), and bolts (2) from support and
frame (1). Discard lockwashers.
4.
Remove oil separator and fuel tank support (3)
from under frame (1).
b. INSTALLATION
NOTE
Both oil separator and fuel tank
supports are installed same way.
This procedure covers one support.
1.
Position oil separator and fuel tank support (3)
under frame (1).
2.
Install six bolts (2), new lockwashers (5), and
nuts (4) on oil separator and fuel tank support (3)
and frame (1).
3.
Remove supports from under fuel tank and from
top of oil separator.
FOLLOW-ON TASKS
Install fender-to-frame panels at front of rear tire and rear of front tire (see paragraph 5-89).
TA705223
5-371/(5-372 Blank)
