and lockwasher. Fasten the cover band in place over the brush openings.
(3) Adjustment. Brushes should be replaced if they measure 1/ inch or less. No adjustment is required,
Figure 33. Generator brushes exposed.
c. Generator Removal (fig. 32).
(1)
Remove the current and voltage regulator (par. 91a).
(2)
Remove the cap screw (31) and lockwashers (32) that attach the bond strap (35) to the upper oil pan.
(3)
Disconnect the ammeter lead wire from the bypass filter (8).
(4)
Remove the hex nut (16) and lockwasher (13) from the lower end of the generator adjusting support (12)
and loosen the upper hex nut.
88
