and shaft (32). Slide off the lever. Drive out the taper pin (18) from the bracket (35) and remove the bracket and shaft.
Drive out the taper pin (18) from the throttle lever (16) and pull off the lever. Reach inside the governor body (23) and
unscrew the yoke (37). Remove the plug (26) and oil seal (19). Remove the two snap rings (20) and withdraw the ball
bearings (21). Slide the rocker shaft (22) from the governor body. Do not tamper with the screws (30) and hex nuts (29).
It is not necessary to remove the button (17).
207. Governor Cleaning and Inspection
Inspect the oilite bearing (1) in the top of the governor body. If any wear is apparent, replace the bearing. Soak the
new bearing in engine oil before installation. Inspect the pin holes in the spider and shaft assembly (4) and weight
assemblies (7). If the holes do not look round, replace both these assemblies. Replace the weight pins (6) if they show
any wear. Replace the thrust bearings (2) if they show any wear.
Inspect the gear (15) for cracks and broken or
chipped teeth. Replace a damaged gear. Check the governor spring (9) for cracks. Replace a cracked spring. If the oil
seal (19) shows any sign of having leaked, replace it. Inspect the ball bearings (21). If they are loose or missing any steel
balls, replace a defective bearing. Replace the gasket (10) and taper pins (18).
208. Governor Reassembly
a. Insert the rocker shaft (22) into the governor body (23). Press the two ball bearings (21) over the ends of the shaft
and seat them in the governor body. Install the two snap rings (20). Install the plug (26) in the recess in the governor body
and slide the oil seal (19) over the shaft extension. Screw the yoke (37) into the threaded hole in the rocker shaft, inside
the governor body. Slide the throttle lever (16) over the shaft extension and drive in the taper pin (18). Slide the bracket
(35) over the shaft (32) and drive in the taper pin (18). Insert the shaft into the speed change bracket (33). Slide the
speed change lever (31) over the shaft and drive in the taper pin (18). Place the thrust sleeve (3) over the spider and shaft
assembly (4). Install the weight assemblies (7), weight pins (6), and hair pin clips (5). Install the upper thrust bearing (2)
over the shaft and thrust sleeve. Install the spacing washer (8) and lower thrust bearing (2) on the shaft below the weight
assembly brackets. Slide the base and bushing assembly (11) on the shaft. Install the thrust washer (14) and
213