• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Replace/Repair Crankshaft Group.
FIGURE 2-17. Replace Crankshaft Group.

TM-55-1905-223-24-8 Air Compressor for Landing Craft Utility (LCU) Manual
Page Navigation
  56    57    58    59    60  61  62    63    64    65    66  
TM 55-1905-223-24-8
REPAIR
Repair consists of replacing the pulley and crankshaft assemblies. Refer to Removal and Replacement steps in this
procedure.
REPLACEMENT
a.
Fit crankshaft (4) into crankcase and slide crankshaft end out hole on pulley side of crankcase. Mke sure
a
bearing (15) seats properly in crankcase.
b.
Install bearing cup (10), spacer plate (12), shim (11), and bearing adjustment plate (13).
c.
Attach bearing adjustment plate with four hex head screws (14).
d.
Install bearing carrier group (paragraph 2-23).
e.
Install key (3).
f.
Slide pulley (1) into crankshaft (4).
g.
Install two 1/2-inch bolts (2) and attach a 1/2-inch nut (16) to each bolt. Tighten to 90 ft-lbs torque.
h.
Place belts (7) over large pulley (1) and smaller motor pulley.
i.
Pull motor away from compressor with a pry bar to tighten belts and tighten motor mounting bolts (9).
j.
Attach and install belt guard (6).
2-53






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.