TM 9-4310-394-13
5-9. REGULATOR BRACKET ASSEMBLY REPAIR AND REPLACEMENT.
This task covers:
a.
Removal
c.
Repair
e.
Adjustment
b.
Inspection
d.
Installation
INITIAL SETUP
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Tachometer (Appendix B, Item 3)
Materials/Parts Required
Diesel Fuel (Appendix E, Item 5)
Equipment Condition
Air compressor unit shut down and cool.
Fuel removed (see para. 4-18).
a. Removal. (Refer to Figure 5-4).
(1)
Remove mounting bolts (1 and 2).
(2)
Remove regulator bracket (3) with regulator lever (4) and springs attached.
(3)
Remove regulator spring (5) from the governor lever (6) and regulator lever (4).
(4)
Remove return spring (7) from the governor lever (6) and regulator lever (4).
(5)
Remove regulator coil spring (8).
(6)
Remove regulator lever (4) from regulator bracket (3) by unscrewing lever locking knob (9) and lock nut
(10).
(7)
Remove adjusting bolt (11) and nut (12).
(8)
Remove wire (13), bolt (14), and nut (15).
b.
Inspection.
(1)
Clean all parts with diesel fuel.
(2)
Inspect all components for damage or excessive wear. Replace any components damaged or worn.
c. Repair. Repair is limited to replacement of defective parts.
d.
Installation.
(1)
Install nut (11) and bolt (12).
(2)
Install nut (15) and adjusting bolt (14).
(3)
Install regulator coil spring (8).
5-10
