• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
B-3.  Explanation of Columns in the MAC - TM-9-4310-396-13_180
SECTION II. MAINTENANCE ALLOCATION CHART - TM-9-4310-396-13_182

TM-9-4310-396-13 Air Compressor Portable 5 CFM Model PD32T5 Manual
Page Navigation
  166    167    168    169    170  171  172    173    174    175    176  
TM9-4310-396-13 d.   Maintenance  Levels  (Column  4).    Column  4  specifies,  by  the  listing  of  a  work  time  figure  in  the  appropriate subcolumn(s), the category of maintenance authorized to perform the function listed in column 3. This figure represents the active time required to perform that maintenance function at the indicated category of maintenance.  If the number or complexity of the tasks within the listed maintenance function vary at different maintenance categories, appropriate work time figures will be shown for each category.  The work time figure represents the average time required to restore an item  (assembly,  subassembly,  component,  module,  end  item,  or  system)  to  a  serviceable  condition  under  typical  field operating   conditions.      This   time   includes   preparation   time   (including   any   necessary   disassembly/assembly   time), troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform the  specific  task  identified  for  the  maintenance  functions  authorized  in  the  maintenance  allocation  chart.    The  symbol designations for the various maintenance categories are as follows: C .......... Crew or Operator O .......... Unit Maintenance F .......... Direct Support Maintenance H .......... General Support Maintenance D .......... Depot Maintenance e.   Tools  and  Equipment  Reference  Code  (Column  5).    Column  5  specifies,  by  code,  those  common  tool  sets (not  individual  tools  ),common  TMDE,  and  special  tools,  special  TMDE,  and  special  support  equipment  required  to perform the designated function. f. Remarks Code (Column 6).  When applicable this column contains a letter code, in alphabetical order, which is keyed to the remarks contained in Section IV. B-4.  Explanation of Columns in Tools and Test Equipment Requirements, Section III. a.   Column  1,  Tools  and  Test  Equipment  Reference  Code .      The   tool   and   test   equipment   reference   code correlates with a code used in the MAC, Section II, Column 5. b.   Column 2, Maintenance Level.  The lowest level of maintenance authorized to use the tool or test equipment. c.   Column 3, Nomenclature.  Name or identification of the tool or test equipment. d.   Column 4, National Stock Number .  The National stock number of the tool or test equipment. e.   Column 5, Tool Number .  The manufacturer's part number. B-5.  Explanation of Columns in Remarks, Section IV. a.   Column 1, Remarks Code.  The code recorded in Column 6, Section II. b.   Column  2,  Remark.    This  column  lists  information  pertinent  to  the  maintenance  function  being  performed  as indicated in the MAC, Section II. B-3







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.