TM 9-4310-397-14
6-10. CONNECTING ROD, PISTONS, RINGS, AND LINERS AND CYLINDER BLOCK INSPECTION AND
REPAIR. - Continued
(e)
If liner height is below specification, install one liner shim on bottom of liner flange. Two sizes of shims
are available.
c.
Repair. Repair is limited to replacement of defective, damaged, or out-of-tolerance parts
d.
Installation.
(1)
Pour Soap Lubricant (item 15, section II, appendix E) into a suitable container.
NOTE
Block preformed packings are installed dry. Use soap only on square packing.
Install new preformed packings, they are available as a kit (item 62, appendix H).
(2)
Install the black preformed packing (Figure 6-88, 1) in the lower preformed packing groove in the cylinder block
(2).
(3)
Install the red (or white) preformed packing (3) in the upper preformed packing groove in the cylinder block (2).
Figure 6-88. Install Preformed Packings
(4)
Turn cylinder liner (Figure 6-89, 1) upside-down. Dip the square packing (2) in soap lubricant (item 15,section II,
appendix E) and install over outside of liner.
6-74
