LO 5-4310-348-12
LUBRICATION
ORDER
21 March 1988
Supersedes L05-4310-348-12, 2 July 1973
COMPRESSOR, AIR, RECIPROCATING, ELECTRIC MOTOR DRIVEN,
RECEIVER, MOUNTED, 2 HP, 5 CFM, 175 PSI (INGERSOLL-RAND
MODEL 234C2) FSN 4310-155-7101
Approved for public release. Distribution is unlimited.
Reference: FEDERAL SUPPLY CATALOG C9100-IL
Hard time intervals and the related task-hour times are
Clean fittings before lubricating.
Lubricate points
based on normal operation.
The task-hour time
indicated by dotted arrow shaft on both sides of
specified is the time you need to do all the services
equipment. Clean parts with drycleaning SOLVENT
prescribed for a particular interval. Change the interval if
(SD), type II or equivalent. Dry before lubricating. Drain
your lubricants are contaminated or if you are operating
crankcase when HOT. Fill and check level. The lowest
the equipment under adverse operating conditions,
level of maintenance authorized to lubricate a point is
including longer-than-usual operating hours.
The
indicated by one of the following: (C) Operator/Crew; or
interval may be extended during periods of low activity.
(O) Organizational Maintenance.
If extended, adequate preservation precautions must be
taken.
You can help improve this publication. If you find any
mistake or if you know of a way to improve the
On-condition (OC) intervals for oil changes shall be
procedures, please let us know. Your letter or DA Form
determined by the Army Oil Analysis Program (AOAP)
2028 (Recommended Changes to Publications and
laboratory and shall be applied unless otherwise notified.
Blank Forms) should be mailed directly to: Commander,
US Army Troop Support Command, ATTN: AMSTR-
Hard time oil change intervals will be applied in the event
MCTS, 4300 Goodfellow Blvd., St. Louis, MO 63120-
AOAP laboratory support is not available.
1798. A reply will be furnished to you.
TOTAL TASK-HR
TOTAL TASK-HR
INTERVAL
TASK-HR
INTERVAL
TASK-HR
W
0.1
A
0.5
Card 1 of 2
