KEY
LO 9-4310-394-12
NOTES:
add to much or too little oil . Do not overfill or engine damage
1. The engine equipped with a rubber plug in the rocker arm
cover to aid starting in cold weather below 10F (-12 C). The
could result. Always check the lube oil level before starting
engine and refill as necessary. Unscrew dipstick and wipe
plug is removed and 5 or 6 drops of ending oil (OE/HDO) is
clean. Observe "H" mark on dipstick indicating engine is filled
added before starting.
properly. Place dipstick into pan: Do not screw dipstick into
oil pan. Remove dipstick and observe oil level. Add oil as
2.
Apply a drop of oil to the component shaft and
needed to bring oil level to top mark of "H".
contact surfaces. Activate component to spread oil evenly.
6. Drain oil with engine stopped and level. Engine oil should
3. When checking oil level, make sure compressor is not
be warm to touch. Check oil for evidence of contamination. If
running and is setting level. Check compressor oil level by
excessive contamination is found, notify direct support
examining sight glass on side of compressor. If oil in sight
maintenance. Install and tighten plug. Unscrew dipstick and
glass is not at least 1/2 full, add oil by removing oil filler tube
fill oil pan with oil OE/HDO as defined in the KEY table above.
on side of compressor and adding oil until sight glass level is.
Screw dipstick into oil pan.
4. Remove drain plug and drain oil with compressor stopped
7. Fill lube gun with MIL-G-10924. Attach gun to grease
and level. Wipe drain plug clean. Oil should be warm to
fitting of each wheel and add 2 to 4 pumps of lube gun handle
touch. Observe oil for evidence of contamination. If excessive
to each wheel.
contamination is found, direct support maintenance must be
notified. Install and tighten drain plug. Unscrew filler plug and
wipe clean. Fill compressor with oil OE/HDO as defined in the
Copy of this lubrication Order will remain with the
KEY table above. Screw filler plug into compressor.
equipment at all times; instructions contained herein are
mandatory.
5. Unscrew one of t two dipstick Check appearance of oil on
dipstick for water contamination, excessive foaming, or particle
contam-ination. If any of the conditions exist, notify unit
maintenance. When checking oil level, make sure engine is
not running and is setting level. If engine is tilted, you may
Card 2 of 3
