Code
Explanation
Federal stock numbers and reference numbers are
cross-referenced to each illustration figure and item
G ......Major assemblies that are procured with PEMA
number appearance.
funds for initial issue only as exchange
3. Explanation of Columns
assemblies at DS and GS level.
These
The following provides an explanation of columns found
assemblies will not be stocked above the DS
in the tabular listing:
and GS level or returned to depot supply level.
a. Source, Maintenance, and Recoverability
NOTE
Codes (SMR).
Cannibalization or salvage may be used as a
source of supply for any items source coded
(1) Source code. Indicates the source for the
above except those coded X1 and aircraft
listed items. Source codes are:
Code
Explanation
support items as restricted by AR 700-42.
(2) Maintenance code.
P ...... Repair parts, special tools, and test equipment
Indicates the lowest
supplied from the GSA/DSA, or Army supply
category of maintenance authorized to install the repair
system, and authorized for use at indicated
part and/or use the special tool or test equipment for
maintenance categories.
each application. Capabilities of higher maintenance
P2 .... Repair parts, special tools, and test equipment
categories are considered equal or better. Maintenance
codes are:
Code
Explanation
purposes because the combat or military
essentiality of the end item dictates that a
C.......................... Crew/operator maintenance
minimum quantity be available in the supply
0 .......................... Organizational maintenance
system.
F .......................... Direct support maintenance
P9 .... Assigned to items which are NSA design
H.......................... General support maintenance
controlled: unique repair parts, special tools,
D.......................... Depot maintenance
(3) Recoverability code. Indicates whether unser-
test, measuring, and diagnostic equipment,
which are stocked and supplied by the Army
viceable items should be returned for recovery or
COMSEC Logistic System and which are not
salvage.
Items not coded are nonrecoverable.
subject to the provisions of AR 380-41
Recoverability codes are:
Code
Explanation
P10 .. Assigned to items which are NSA
design
controlled: special tools, test, measuring, and
R..... Applied to repair parts, (assemblies and
diagnostic equipment for COMSEC support,
components), special tools, and test equipment
which are accountable under the provisions of
which are considered economically reparable at
AR 380-41, and which are stocked and supplied
direct and general support maintenance levels.
by the Army COMSEC Logistic System.
When the item is no longer economically
M...... Repair parts, special tools, and test equipment
reparable, it is normally disposed of at the GS
which are not procured or stocked, as such, in
level. When supply considerations dictate, some
the supply system but are to be manufactured
of these repair parts may be listed for automatic
at indicated maintenance levels.
return to supply for depot level repair as set forth
A ...... Assemblies which are not procured or stocked as
in AR 7101. When so listed, they will be
such, but are made up of two or more units
replaced by supply on an exchange basis.
Such component units carry individual stock
S ..... Repair parts, special tools, test equipment, and
numbers and descriptions, are procured and
assemblies which are economically reparable at
stocked separately and can be assembled to
DSU and GSU activities and which normally are
form the required assembly at indicated
furnished by supply on an exchange basis.
maintenance categories.
When items are determined by a GSU to be
X ...... Parts and assemblies that are not procured or
uneconomically reparable, they will be evacuated
stocked because the failure rate is normally
to a depot for evaluation and analysis before
below that of the applicable end item or
final disposition.
component.
The failure of such part or
T ..... Higher dollar value recoverable repair parts, special
assembly should result in retirement of the end
tools, and test equipment which are subject to
item from the supply system.
special handling and are issued on an exchange
X1 .... Repair parts which are not procured or stocked.
basis. Such items will be repaired or overhauled
The requirement for such items will be filled by
at depot maintenance activities only. No repair
the next higher assembly or component.
may be accomplished at lower levels.
X2 .... Repair parts, special tools, and test equipment
U..... Repair parts, special tools, and test equipment
which are not stocked and have no foreseen
specifically selected for salvage by reclamation
mortality. The indicated maintenance category
units because of precious metal content, critical -
requiring such repair parts will attempt to obtain
materials, high dollar value, or reusable casings
the parts through cannibalization or salvage.
or castings.
The item may be requisitioned, with exception
b. Federal Stock Number. Indicates the Federal
data, from the end item manager for immediate
stock number assigned to the item and will be used for
use.
requisitioning purposes.
c. Description. Indicates the Federal item name
2