TM 3-1040-263--34
1 Packing nut
7
Lockwasher
14
Preformed packing
2 Stem assembly
8
Aftercooler nut
15
Elbow assembly
3 Spray fitting and needle valve
9
Clamp
16
Preformed packing
body
10
Water separator assembly
17
Parking retainer
4 Spray fitting
11
Outlet plug
18
Locknut
5 Needle valve
12
Preformed packing
19
Elbow
6 Nut
13
High-pressure relief valve
20
Water separator
Figure 8-1--Continued.
Section II. INSTRUCTION PLATE AND PROTECTING CAGE
3-7. Protecting Cage
3-5.
General
Direct support maintenance personnel are authorized to
a
Removal. Disconnect the four protecting
replace the instruction plate, attaching hardware, and
cage nuts and remove the protecting cage (7).
protecting cage.
b. Cleaning. Clean the protecting cage with
drycleaning solvent.
3-6.
Instruction Plate
c. Inspection. Inspect the protecting cage for
a. Removal. (1) Remove canvas cover (TM 3-
bends, breaks, scratches, damaged threads, broken
1040-26312).
welds, and other defects.
Installation.
d.
attaching hardware (items 1 through 5) and remove
instruction plate (6).
(1) Position the protecting cage (7) on the
b.
Installation. Installation is the reverse
engine mounting frame (38) and secure in place using
of removal (a above).
the four protecting cage nuts.
(2) Install canvas cover (TM 3-1040-263-
12).
3-3