TM
5-4310-275-14
KEY to Figure 7-4.
(12) Remove cotter pins (3) and push the
1. Crankcase
piston pin (4) out of the master connecting rod.
2. Stud
Remove connecting link (31), using care to
3. Cotter pin
prevent loss of the twenty-five needle bearings
4. Piston pin
(32) and two washers (5 and 33).
5. Bearing washer
6. Cotter pin
(13) Remove cotter pin (6) and push piston
7. Piston pin
pin (7) out of the master connecting rod, using
8. Bearing washer
care to prevent loss of the twenty-five needle
9. Bearing
bearings (9) and washers (8 and 11). Remove
10. Second stage connecting lir
11. Bearing washer
connecting link (10).
12. Ball retainer
(14) Pull bearings (30) from the master
13. Rod socket
connecting rod.
14. Ball
(15) Push bearing (34) out of the master
15. Oil pump piston assembly
16. Shim
connecting rod.
17. Retainer
18. Cylinder
19. Screw
20. Retainer
21. Pin
22. Sems fastener
23. Preformed packing
24. Drain plug
25. Oil reservoir
26. Preformed packing
27. Oil level sight gage
28. Gasket
29. Master connecting rod
30. Bearing
31. Third stage connecting link
32. Bearing
33. Bearing washer
34. Bearing
35. Endbell
36. Nut
37. Identification plate
38. Drive screw
39. Gasket
40. Oil seal
41. Bearing
42. Crankshaft
43. Thrust washer
44. Drive bushing
45. Retaining plate
46. Locating pin
47. Bearing
48. Oil seal
7-10
