TM 5-4310-335-20P
SECTION I
INTRODUCTION
1.
Scope
Code Explanation
M
Applied to repair parts which are not procured or
This manual lists repair parts and special tools, required
stocked but are to be manufactured at indicated
for the performance of organizational maintenance of the
maintenance categories.
A
Applied to assemblies which are not pros cured or
2.
General
stocked as such but are made up of two or more
units, each of which carry individual stock
This Repair Parts and Special Tools List is divided into
numbers and descriptions and are procured and
the following sections:
stocked and can be assembled by units at
a.
Prescribed Load Allowance (PLA)-Section II.
indicated maintenance categories.
A composite listing of the repair parts, special tools, test
X
Applied to parts and assemblies which are not
and support equipment having quantitative allowances for
procured or stocked; the mortality of which
initial stockage at the organizational level.
normally is below that of the applicable end item;
b.
and the failure of which should result in retirement
authorized for the performance of maintenance at the
of the end item from the supply system.
organizational level in figure and item number sequence.
X1 Applied to repair parts which are not procured or
c.
Special Tools, Test and Support Equipment -
stocked, the requirement for which will be
Section IV. (Not applicable).
supplied by use of the next higher assembly or
d.
Federal Stock Number and Reference Number
component.
X2 Applied to repair parts which are not stocked. The
ascending numerical sequence followed by a list of
indicated maintenance category requiring such
reference numbers in ascending alpha-numeric sequence,
repair parts will attempt to obtain them through
cross-referenced to the illustration figure number and item
cannibalization; if not obtainable through
number.
cannibalization, such repair parts will be
requisitioned with supporting justification through
3.
Explanation of Columns
normal supply channels.
The following provides an explanation of columns in the
C
Applied to repair parts authorized for local
tabular lists in sections II, III, and IV.
procurement. If not obtainable from local
a.
Source, Maintenance, and Recoverability
procurement, such repair parts will be
Codes (SMR).
requisitioned through normal supply channels with
a supporting statement of nonavailability from
Note
local procurement.
Common hardware items known to
G
Applied to major assemblies that are procured with
be readily available in Army supply
PEMA (Procurement Equipment Missile Army)
channels are assigned Maintenance
funds for initial issue only to be used as exchange
codes
only.
Source
codes,
assemblies at DSU and GSU maintenance level.
Recoverability
codes,
and
These assemblies will not be stocked above DSU
Maintenance Allowances are not
and GSU level or returned to depot supply level.
assigned this category.
(2) Maintenance code, indicates the lowest
(1) Source code, indicates the selection
category of maintenance authorized to install the listed
status and source for the listed item. Source codes are:
item. The maintenance level code is:
Code
Explanation
Code
Explanation
P
Applied to repair parts which are stocked in or
O
Organizational maintenance
supplied from DSA/GSA or Army supply system,
(3) Recoverability code, indicates whether
and authorized for use at indicated maintenance
unserviceable items should be returned for recovery or
categories.
salvage. Items not coded are expendable. Recoverability
P2
Applied to repair parts which are procured and
codes are:
stocked for insurance purposes because the
Code
Explanation
combat or military essentiality of the end item
R
Applied to repair parts and assemblies which are
dictates that a minimum quantity be available in
the supply system.
iii
