TM 5-4310-335-35P
SECTION I
INTRODUCTION
1. Scope
Code
Explanation
end item dictates that a minimum quantity
This manual lists repair parts and special tools required
be available in the supply system.
for the performance of direct support, general support,
M
Applied to repair parts which are not procured
and depot maintenance of the Compressor.
or stocked but are to be manufactured at
2. General
indicated maintenance categories.
A
Applied to assemblies which are not pro cured
This Repair Parts and Special Tools List is divided into
or stocked as such but are made up of
the following sections:
two or more units, each of which carry
individual stock numbers and description
and are procured and stocked and can be
authorized for the performance of maintenance at the
assembled at indicated maintenance
direct support; general support, and depot level in figure
categories.
and item number sequence.
X
Applied to parts and assemblies which are not
procured or stocked; the mortality of
b. Special Tools, Test and Support Equipment --
which normally is below that of the
Section III. (Not applicable).
applicable end item; and the failure of
which should result in retirement of the
c. Federal Stock Number and Reference Number
end item from the supply system.
X1
Applied to repair parts which are not procured
ascending numerical sequence followed by a list of
or stocked, the requirements for which will
reference numbers in ascending alpha-numeric
be supplied by use of the next higher
sequence, cross referenced to the illustration figure
assembly or component.
number and item number.
X2
Applied to repair parts which are not stocked.
The indicated maintenance category
3. Explanation of Columns
requiring such repair parts will attempt to
The following provides an explanation of columns in the
obtain them through cannibalization; if not
obtainable through cannibalization, such
repair parts will be requisitioned with
a. Source, Maintenance, and Recoverability Codes
supporting justification through normal
(SMR).
supply channels.
C
Applied to repair parts authorized for local
Note
procurement. If not obtainable from local
Common hardware items known to
procurement, such repair parts will be
requisitioned through normal supply
be readily available in Army supply
channels with a supporting statement of
channels are assigned maintenance
nonavailability from local procurement.
codes
only.
Source
codes,
G
Applied to major assemblies that are procured
recoverability
codes,
and
with PEMA (Procurement Equipment
maintenance allowances are not
Missile Army) funds for initial issue only to
be used as exchange assemblies at DSU
assigned to this category.
and GSU maintenance level.
These
(1) Source code, indicates the selection
assemblies will not be stocked above
DSU and GSU level or returned to depot
status and source for the listed item. Source codes
supply level.
used are:
(2) Maintenance code, indicates the lowest
Code
Explanation
category of maintenance authorized to install the listed
P
Applied to repair parts which are stocked in or
item. The maintenance level codes are:
supplied from DSA/GSA or Army supply
system, and authorized for use at
Code
Explanation
indicated maintenance categories.
O ...........................Organizational maintenance
P2
Applies to repair parts which are procured and
F ...........................Direct support maintenance
stocked for insurance purposes because
H ...........................General support maintenance
the combat or military essentially of the
D ...........................Depot maintenance
iii
