TM 5-4310-343-34P
SECTION I
INTRODUCTION
3. Explanation of Columns
1. Scope
The following provides an explanation of columns in the
a. This manual lists repair parts, special tools, test
tabular lists in Sections II and III:
and support equipment required for the performance of
a. Source, Maintenance, and Recoverability Code
direct support, general support, and depot maintenance
(SMR).
of the compressor.
(1) Source code indicates the source for the
b. Repair parts listed represent those authorized
listed items. Source codes are:
for use at indicated maintenance levels and will be
requisitioned (on an "as required" basis until stockage is
Code
Explanation
justified by demand in accordance with AR 735-35 or AR
710-2).
P
Repair Parts, Special Tools and Test Equipment
supplied from GSA/DSA, or Army supply
2. General
system, and authorized for use at indicated
maintenance levels.
This Repair Parts and Special Tools List is divided into
P2
Repair Parts, Special Tools and Test Equipment
the following sections:
which are procured and stocked for insurance
purposes because the combat or military
item number sequence, of repair parts authorized for the
essentiality of the end item dictates that a
performance of maintenance at the direct support,
minimum quantity be available in the supply
general support, and depot level, including those items
system.
which must be removed for replacement of the
M
Repair Parts, Special Tools and Test Equipment
which are not procured or stocked, as such, in
authorized item. Items, except kits and sets, are listed
the supply system but are to be manufactured
by assembly groups in top down breakdown sequence.
at indicated maintenance levels.
Repair parts kits and sets are listed separately as Group
A
Assemblies which are not procured or stocked
05 at the end of the Repair Parts List without regard to
as such, but are made up of two or more units.
the assembly group to which they belong. Components
Such component units carry individual stock
of the kits and sets are listed in their proper sequence in
numbers and descriptions, are procured and
the assembly group to which they belong and are
stocked separately and can be assembled to
referenced to the FSN of the kit or set.
form the required assembly at indicated
b. Special Tools, Test and Support Equipment -
maintenance levels.
Section III. A list of special tools, test and support
X
Parts and assemblies that are not procured or
equipment authorized for the performance of
stocked because the failure rate is normally
maintenance at the direct support, general support, and
below that of the applicable end item or
depot level. (Not applicable.).
component.
The failure of such part or
c. Federal Stock Number and Reference Number
assembly should result in retirement of the
end item from the supply system.
ascending numerical sequence followed by a list of
X1
Repair Parts which are not procured or stocked,
reference
numbers
in
ascending
alphanumeric
The requirement for such items will be filled by
sequence, cross-referenced to the illustration figure
the next higher assembly or component.
number and item number.
X2
Repair Parts, Special Tools, and Test
Equipment which are not stocked and have no
NOTE
foreseen
mortality.
The
indicated
maintenance level requiring such repair parts
Items not illustrated are
cross-
will attempt to obtain the parts through
referenced to group number.
cannibalization or salvage, if not obtainable
through cannibalization or salvage, the item
may be requisitioned with exception data, from
the end item manager, for immediate use.
iii
