TM 5-4310-344-34P
SECTION I
INTRODUCTION
P2
Repair Parts, Special Tools and Test Equipment which
1. Scope
are procured and stocked for insurance purposes
This manual lists repair parts required for the
because the combat or military essentially of the
performance of direct support, general support, and
end item dictates that a minimum quantity be
depot maintenance of the compressor.
available in the supply system.
2. General
M
Repair Parts, Special Tools and Test Equipment which
This Repair Parts and Special Tools List is divided into
are not procured or stocked, as such, in the supply
the following sections:
system but are to be manufactured at indicated
a. Repair Parts Section II. A list, in figure and item
maintenance levels.
number sequence, of repair parts authorized for the
A
Assemblies which are not procured or stocked as such,
performance of maintenance at the direct support,
but are made up of two or more units.
general support, and depot level, including those items
which must be removed for replacement of the
Such component units carry individual stock numbers and
authorized item. Items, except kits and sets, are listed
descriptions, are procured and stocked separately
by assembly groups in top down breakdown sequence.
and can be assembled to form the required
Repair parts kits and sets are listed separately as Group
assembly at indicated maintenance categories.
07 at the end of the Repair Parts List without regard to
the assembly group to which they belong. Components
X
Parts and assemblies that are not procured or stocked
of the kits and sets are listed in their proper sequence in
because the failure rate is normally below that of
the assembly group to which they belong and are
the applicable end item or component.
The
referenced to the FSN of the kit or set.
failure of such part or assembly should result in
retirement of the end item from the supply system.
b. Special Tools, Test and Support Equipment
Section III. A list of special tools, test and support
X1 Repair Parts which are not procured or stocked. The
equipment authorized for the performance of
requirement for such items will be filled by the next
maintenance at the direct support, general support, and
higher assembly or component.
depot level Not applicable.
c. Federal Stock Number and Reference Number
X2 Repair Parts, Special Tools, and Test Equipment which
Index Section IV. A list of Federal stock numbers in
are not stocked and have no foreseen mortality.
ascending numerical sequence followed by a list of
The indicated maintenance category requiring such
reference numbers in ascending alpha-numeric
repair parts will attempt to obtain the parts through
sequence, cross-referenced to the illustration figure
cannibalization or salvage, the item may be
requisitioned with exception data, from the end
number and item number.
item manager, for immediate use.
Note. Items not illustrated are 'cross-referenced to
group number.
G
Major assemblies that are procured with PEMA funds
for initial issue only as exchange assemblies at
3. Explanation of Columns
DSU and GSU level. These assemblies will not be
The following provides an explanation of columns in the
stocked above DS and GS level or returned to
tabular lists in sections II and III:
depot supply level.
a. Source, Maintenance, and Recoverability Code
(SMR).
(2) Maintenance code. Indicates the lowest
category of Maintenance authorized to install the listed
(1) Source code. Indicates the source for the
item. The maintenance level codes are:
listed items. Source codes are:
Code
Explanation
Code
Explanation
P
Repair Parts, Special Tools and Test Equipment
C
Operator/Crew maintenance
supplied from GSA/DSA, or Army supply system,
O
Organizational maintenance
and authorized for use at indicated maintenance
F
Direct Support maintenance
categories.
H
General Support maintenance
D
Depot maintenance
iii
