TM 5-4310-348-24P
h. One-Year Allowances Per 100 Equipment/Contingency Planning Purposes. Items authorized for use as
required but not for initial stockage are identified with an asterisk in the allowance columns.
i. Depot Maintenance Allowance Per 100 Equipment. Items authorized for use as required but not for initial
stockage are identified with an asterisk in the allowance column.
j. Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number of the illustration on which the item is shown.
(2) Item number. Indicates the callout number used to reference the item on the illustration.
4. Special Information
a. The basis of issue for authorized special tools, test and support equipment is the number of end items of
equipment supported and the number of maintenance personnel allocated to perform the required maintenance
operations.
b. Parts which require manufacture or assembly of a maintenance level higher than that authorized for
installation will indicate in the source column the higher maintenance level.
c. Repair parts kits and gasket sets appear as the last entries in the repair parts listing for the group or
assembly to which they apply.
d. (Applicable to revision and/or change only). Action change codes indicated in the left-hand margin of the
listing page denote the following:
N-Indicates an added item.
C-Indicates a change in data.
R-Indicates a change in FSN only.
e. The following publications pertain to the air compressor and its components:
TM 5-4310-348-14 Operator, Organizational, Direct and General Support and Depot Maintenance
Manual
L05-4310-348-12
Lubrication Order
5. How to Locate Repair Parts
a. When Federal stock number or reference number is unknown:
(1) First. Using the table of contents, determine the assembly group within which the repair part
belongs.This is necessary since illustrations are prepared for assembly groups, and listings are
divided into the same groups.
(2) Second. Find the illustration covering the assembly group to which the repair part belongs.
(3) Third. Identify the repair part on the illustration and note the illustration figure and item number
of the repair part.
(4) Fourth. Using the Repair Parts Listing, find the assembly group to which the repair part belongs and
locate the illustration figure and item number noted on the illustration.
b. When the Federal stock number or reference number is known:
(1) First. Using the Index of Federal Stock Numbers and Reference Numbers find the pertinent Federal
stock number or reference number.
This index is in ascending FSN sequence followed by a list of
reference numbers in alpha-numeric sequence, cross-referenced to the illustration figure number
and item number.
(2) Second. Using the Repair Parts Listing, find the assembly group of the repair part and the illustration
figure number and item number referenced in the Index of Federal Stock Numbers and Reference
Numbers.
6. Abbreviations
ea ........................................ each
hd ........................................ head
hex ...................................... hexagon
hp ........................................ high pressure
lp ......................................... low pressure
mtg ...................................... mounting
7. Recommendations for Maintenance Publications Improvements
You can improve this manual by calling attention to errors and by recommending improvements, using DA
Form 2028 (Recommended Changes to Publications) or by a letter, and mailing directly to Commander, U.S.
Army Troop Support Command, ATTN: AMSTS-MPP, 4300 Goodfellow Boulevard, St. Louis, Missouri 63120.
A reply will be furnished directly to you.
v
