TM 5-4310-356-14
APPENDIX B
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
tify item called out in the illustration.
B-1. Scope.
This appendix lists Integral Components of and
b. National Stock Number (NSN). Indicates the
Basic Issue Items (BII) for the Air Compressor to help
national stock number assigned to the end item which
you inventory items required for safe and efficient
will be used for requisitioning.
operation.
c. Part Number (P/N). Indicates the primary
number used by the manufacturer which controls the
B-2. General.
design and characteristics of the item by means of its
engineering drawings, specifications, standards and
The components of end item list are divided into
inspection requirements to identify an item or range of
the following sections:
items.
a. Section II. Integral Components of the End
d. Description. Indicates the federal item name
Item. These items, when assembled, comprise the Air
and, if required, a minimum description to identify the
Compressor and must accompany it whenever it is
item.
transferred or turned in. These illustrations will help you
e. Location. The physical location of each item
identify these items.
listed is given in this column. The lists are designed to
b. Section III. Basic Issue Items. These are
inventory all items in one area of the major item before
minimum essential items required to place the Air
moving on to an adjacent area.
Compressor in operation, to operate it and to perform
f. Usable on Code. "Usable On" codes are
emergency repairs.
Although shipped separately
included to help you identify which component items are
packed, they must accompany the Compressor during
used on the different models. Identification of the codes
operation and whenever it is transferred between
used in this list are:
accountable officers. The illustrations will assist you
with hard-to-identify items.
This manual is your
Code
Used On
authority to requisition replacement BII based on
Table(s)
of
Organization
and
Equipment
MAA
Model HR2-6M-1
(TOE)/Modification Table of Organization and
Equipment (MTOE) authorization of the end item.
g. Quantity Required (Qty Reqd). This column
lists the quantity of each item required for a complete
B-3. Explanation of Columns.
major item.
a. Illustration. This column is divided as follows:
h. Quantity. This column is left blank for use
(1) Figure Number. Indicates the figure
during inventory. Under the received column, list the
number of the illustration on which the
quantity you actually receive on your major item. The
item is shown (if applicable).
date columns are for use when you inventory the major
item at a later date, such as for shipment to another site.
(2) Item Number. The number used to iden-
B-1
