TM 5-4310-358-24P
5. SPECIAL INFORMATION.
a.
USABLE ON CODE. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as "UOC: ....." in the Description Column (justified left):on the last line applicable
item description/ nomenclature. Uncoded items are applicable to all models.
b.
ASSOCIATED PUBLICATIONS. The publications listed below pertains to the Compressor, Air
Reciprocating, and its components.
Publication
Short Title
TM 5-4310-360-14
Compressor Air, Reciprocating:
175 PSI
LO 5-4310-358-12
Lubrication Order for Compressor,
Air, Reciprocating: 175 PSI
6. HOW TO LOCATE REPAIR PARTS.
a. When National Stock Number or Part Number is NOT Known.
(1)
First. Using the table of contents, determine the assembly group for subassembly group to which the item
belongs. This is necessary since figures are prepared for assembly groups and subassembly groups, and
listings are divided into the same groups.
(2)
Second. Find the figure covering the assembly group or subassembly group to which the item belongs.
(3)
Third. Identify the item on the figure and note the item number.
(4)
Fourth. Refer to the Repair Parts List for the figure to find the part number for the item number noted on
the figure.
(5)
Fifth. Refer to the Part Number Index to find the NSN, if assigned.
b.
When National Stock Number or Part Number is Known:
(1)
First. Using the Index of National Stock Numbers and Part Numbers, find the pertinent National Stock
Number or Part Number. The NSN index is in National Item Identification Number (NIIN) sequence (see
4a(1)). The part numbers in the Part Number index are listed in ascending alphanumeric sequence (see
paragraph 4b). Both indexes cross-reference you to the illustration figure and item number of the item you
are looking for.
(2)
Second. After finding the figure and item number, verify that the item is the one you are looking for, then
locate the item number in the repair parts list for the figure.
7. ABBREVIATIONS. Abbreviations used in this manual are listed in MIL-STD-12.
8
