TM 5-4310-372-14
INLET AIR FILTER, CYLINDER HEAD
4-27.
CLEANING, INSPECTION AND REPAIR
AND VALVES -
- continued
cont’d.
2
CAUTION
Do not attempt to clean the valve reeds or the
v a l v e p l a t e i n t h e v i c i n i t y o f t h e r e e d s w i th
a sharp instrument.
Use solvent in these areas.
5.
High Pressure Valve
a .
Using a razor blade
Assembly
or similar tool gently
remove all traces of
gasket and carbonized
oil residue from the
valve plate.
b.
If valve problems
13 to 16
are suspected (due to
poor performance) or
visual inspection
determines that the
reeds are damaged or not
t i g h t l y s e a t i n g a g a i n st
the valve plate, unscrew
the machine screws, washers
and nuts securing the
valve reeds to the plate.
WARNING
D r y c l e a n i n g s o l v e n t P - D - 6 8 0 , u s e d t o c l e a n
p a r t s , i s p o t e n t i a l l y d a n g e r o u s t o p e r s o n n e l
a n d p r o p e r t y .
Avoid repeated and prolonged
s k i n c o n t a c t b y w e a r i n g r u b b e r o r s o l v e nt
impermeable gloves when handling the solvent or
m a t e r i a l w e t w i t h d r y c l e a n i n g s o l v e n t.
Wash
hands immediately after exposure with soap and
w a t e r a n d u s e a l a n o l i n b a s e d s k i n c r e a m to
p r e v e n t s k i n d r y i n g.
Do not use near open
flame or excessive heat.
Flash point of sol-
vent is 100°F (38°C).
Ensure that ventilation
is, adequate to reduce solvent vapor concentra-
tions below acceptable threshold limit values.
4-42
