Controls and Indicators (Cont) - TM-5-4310-379-14

Figure 3-71. Oil Pressure Gage Compressor, Replace.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
183

TM 5-4310-379-14 3-46. Controls and Indicators (Cont). (9) Oil pressure gage (compressor). (figure 3-71) (a) Loosen fitting nut (1) and remove oil line (2). (b) Loosen fitting nut (3) and remove oil line (2) from elbow (4). (c) Remove two nuts (5), washers (6), and brackets (7) and remove gage (4). (d) Remove elbow (8) from gage (4). NOTE Leave 1 1/2 threads exposed when applying teflon tape. Wrap teflon tape in the direction that will not unwrap as fitting is tightened. Failure to wrap teflon tape properly or having it extend past the end of the fitting may cause a blockage in the fuel system. (e) Apply teflon tape to threads on gage (4). (f) Install elbow (8) on gage (4). (g) Install gage (4) and secure with bracket (7), two washers (6) and nuts (5). (h) Install oil line (2) and tighten fitting nut (3). (i) Install oil line (2) and tighten fitting nut (1). 3-158 Change 1

Privacy Statement
Press Release
Contact