Portable Air Filtration System Filter Assemblies

Figure 4-46. Filter Assemblies, Service (5 and 10 Micron).

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
318

TM 5-4310-379-14 4-34. Portable Air Filtration System Filter Assemblies This task covers: a. Service (5 and 10 micron) d. Repair (5 and 10 micron b. Service (Coalescing) e. Repair (Coalescing) c. Replace INITIAL SETUP: Tools Materials/Parts (Cont) General Mechanic's Tool Kit (NSN 5180-00-177-7033) Tape (Item 23, Appendix D) TSP Ultrasonic Cleaner w/Heater (Item 35, Appendix B) Bands, Rubber (Item 5, Appendix D) Bags, Plastic (Item 4, Appendix D) Materials/Parts Water, Distilled (Item 11, Appendix D) Teflon Tape (Item 24, Appendix D) Filter Assembly (5 Micron) Nonionic Detergent (Item 10, Appendix D) Filter Assembly (10 Micron) Phosphate, Trisodium (Item 20, Appendix D) Filter Assembly (Coalescing) a. Service 5 and 10 Micron Air Filter Assemblies. (figure 4-46) WARNING Cleanliness is imperative in maintaining and handling diving air system components. All tools and parts must be kept free of oil, grease, rust, or other contamination in accordance with accepted army diving cleaning procedures. Foreign substances within an assembly could result in equipment failure and possible injury or death to personnel. Ensure that all air lines and components removed or openings into the air system that provides breathing air are covered with a plastic bag and secured with a rubber band or taped shut. Small components should be stored in a plastic bag and sealed. Failure to do so will cause air system to become contaminated and could result in injury or death to the diver. (1) Unscrew shell (1) and remove. (2) Unscrew base (2) and remove gasket (3), filter (4), gasket (5), top (6), and o-ring (7). (3) Clean shell (1), base (2), and top (6) with TSP ultrasonic cleaner w/heater following cleaning instructions in Chapter 3. Clean components soft goods in accordance with Chapter 3. (4) Install o-ring (7) on top (6) and install top (6), gasket (5), filter (4), gasket (3), and base (2). (5) Install shell (1). 4-112

Privacy Statement
Press Release
Contact