TM 5-4310-379-14
5-19. Cylinder Head.
This task covers:
Replace
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tool Kit
Upper water connection removed (para. 3-20).
(NSN
5180-00-177-7033)
Injector control removed (para. 4-9)
Wrench, Torque (NSN 5120-00-554-7292)
Injectors removed (para. 4-9)
Sled Gage (PN J 22273-01)
Governor removed (para. 4-11)
Injector Tube Kit (PN J 22525)
Magnetic Crack Detector (NSN 6635-01-128-2676)
Wrench, Torque (NSN 5120-00-554-7292)
Materials/Parts
Cylinder Head
Lifting Bracket Gasket
Tape, Teflon (Item 25, Appendix D)
Oil Seal Gasket
Cylinder Head Gasket
a.
Remove. (figure 5-20)
(1)
Loosen fitting nut (1) and remove temperature sensor (2).
(2)
Loosen fitting nut (3) and remove fuel line (4).
(3)
Loosen two fitting nuts (5) and remove line (6).
(4)
Remove two bolts (7) and lockwashers (8) and remove upper valve operating mechanism (9) and three push rod
seats (10).
(5)
Remove two bolts (11) and washers (12) and remove upper valve operating mechanism (13) and three push rod
seats (14).
(6)
Connect lifting device to lifting eyes (15).
(7)
Remove six bolts (16) and remove cylinder head (17), gasket (18), and oil seal gasket (19).
(8)
Remove three bolts (20) and lockwashers (21) and remove rear lifting bracket (22) and gasket (23).
(9)
Remove three bolts (24) and lockwashers (25) and remove thermostat housing assembly (26) and gasket (27).
(10)
Remove two elbows (28).
(11)
Remove two valve cover studs (29).
Change 1 5-64