TM 5-4310-379-14
3-13. Engine Assembly (Cont).
b.
Removal. (figure 3-4)
(1)
Remove nut (1) and lockwasher (2) and tag and remove negative cable (3) from starter (4).
(2)
Remove nut (5) and tag and remove positive cable (6) from starter (4).
(3)
Open pet cock (7) and drain coolant into suitable container.
(4)
Loosen clamp (8) and remove hose (9) from radiator neck (10).
(5)
Loosen clamp (11) and remove hose (12) from water pump (13).
(6)
Remove ten screws (14) and remove two fan guards (15).
(7)
Remove four screws (16) and nuts (17) and remove shell (18).
(8)
Disconnect tachometer cable (19) from adapter (20).
(9)
Loosen fitting nut (21) and remove starting fluid line (22).
(10)
Remove 12 screws (23) and remove cover (24).
(11)
Remove five screws (25) and nuts (26) and remove drive belt shroud (27).
(12)
Loosen four screws (28).
(13)
Loosen four screws (29), and loosen adjusting screw (30) and move compressor (31) toward engine (32)
enough to remove four drive belts (33).
(14)
Tag and remove wiring from starter (4), alternator (34), and low oil pressure shutdown switch (35) and
move wiring harness (36) out of way.
(15)
Loosen fitting nut (37) and disconnect oil line (38).
(16)
Loosen fitting nut (39) and remove coolant temperature sensor (40).
(17)
Disconnect fuel line (41) from strainer (42).
(18)
Disconnect fuel line (43) from cylinder head (44).
(19)
Loosen screw (45).
(20)
Loosen two screws (46) and disconnect stop control cable (47).
(21)
Loosen screw (48).
(22)
Loosen two screws (49) and disconnect throttle cable (50).
(23)
Remove four screws (51) and nuts (52).
(24)
Remove four nuts (53) and remove exhaust muffler (54) and gasket (55).
(25)
Connect suitable lifting device to lifting eyes (56) and remove engine (32).
3-22
