TM 5-4310-379-14
(3)
Install engine (32) and secure with four screws (51) and nuts (52).
(4)
Install exhaust muffler (54) and gasket (55) and secure with four nuts (53).
(5)
Install throttle cable (50) and tighten two screws (49) and screw (48).
(6)
Install stop control cable (47) and tighten two screws (46) and screw (45).
(7)
Connect fuel line (43) to cylinder head (44).
(8)
Connect fuel line (41) to strainer (42).
(9)
Install coolant temperature sensor (40) and tighten fitting nut (39).
(10)
Connect oil line (38) and tighten fitting nut (37).
(11)
Connect wiring harness (36) to starter (4), alternator (34), and low oil pressure shutdown switch (35) as
tagged.
(12)
Install four drive belts (33) and tighten adjusting screw (30) until a firm push midway between PTO pulley
(63) and compressor pulley (64) deflects drive belts 0.50-0.75 in (1.27-1.90 cm).
(13)
Tighten four screws (28).
(14)
Tighten four screws (29).
(15)
Install drive belt shroud (27) and secure with five screws (25) and nuts (26).
(16)
Install cover (24) and secure with 12 screws (23).
(17)
Install starting fluid line (22) and tighten fitting nut (21).
(18)
Connect tachometer cable (19) to adapter (20).
(19)
Install shell (18) and secure with four screws (16) and nuts (17).
(20)
Install fan guards (15) and secure with ten screws (14).
(21)
Install hose (12) on water pump (13) and tighten clamp (11).
(22)
Install hose (9) on radiator neck (10) and tighten clamp (8).
(23)
Close pet cock (7).
(24)
Remove radiator cap (65) and fill radiator (66) with coolant and install radiator cap (65).
(25)
Remove fill cap (67) and fill engine with oil to F mark on dipstick (68).
(26)
Install positive cable (6) and secure with nut (5).
(27)
Install negative cable (3) and secure with nut (1) and lockwasher (2).
3-31