TM 5-4310-384-13
CLEANING.
WARNING
Clean motor components with compressed air no greater than 30 psi. Protective eyewear must be worn
when cleaning with compressed air or scraping paint.
a.
Remove any loose paint from frame.
b.
Blow off rotor and stator assemblies (5and 15)with compressed air. Wipe rotor assembly(5)with clean rag.
c.
Wipe off bearings (7) with clean rag if grease is dry or dirty. Apply a coat of new bearing grease.
d.
Clean endplate (1 and 2) vent slots with compressed air and wipe off with clean rag.
ASSEMBLY.
NOTE
Be sure capacitors are in padding before installing.
a.
Install capacitors (12 and 13) and capacitor cover (1-1).
b.
Install stationary switch (10).
c.
Install thrust washer (9).
d.
Install rear endplate (2).
e.
Install rotating assembly (8).
f.
Press bearings (7) onto rotor assembly.
g.
Install rotor assembly (5).
h.
Install bearing guards (6) into front endplate (1) if any were removed.
i.
Install front endplate (1).
j.
Install thru bolts (3) and nuts (4). Tighten nuts.
k.
Install electric motor onto tank frame. Refer to paragraph 3-33.
4-13 (4-14/Blank)
