TM 5-4310-386-14
4-29. Engine Assembly (Cont).
b.
Replace.
(1)
Removal. (figure 4-35)
(a)
Remove two bolts (1) and washers (2) securing throttle control (3) to outer frame (4) and remove
throttle control.
(b)
Remove bolt (5), lockwashers (6), washer (7), ground wire (8), and washer (9).
(c)
Remove nine bolts (10), lockwashers (11), and 18 washers (12) and remove top frame bars (13) and
(14) from outer frame (4).
(d)
Remove two screws (15) and tag and remove three wires (16) from shutdown device (17).
(e)
Loosen screw (18) on clamp (19) and remove line (20).
(f)
Loosen fitting nut (21) and remove line (22).
(g)
Remove nut (23) and tag and remove wire (24), and battery cable (25) from starter (26).
(h)
Remove screw (27) and tag and remove wire (28) from starter(26).
(i)
Loosen five screws (29) and pull off cover (30) from alternator (31).
(j)
Remove nut (32), lockwashers (33), and tag and remove wire (34).
(k)
Remove nut (35), washer (36), and tag and remove wire (37).
(I)
Remove nut (38), washer (39), and tag and remove wire (40).
(m)
Remove wire (41) from connector on alternator (31).
(n)
Attach suitable lifting device to engine.
(o)
Remove two bolts (42), lockwashers (43), and nuts (44).
(p)
Remove engine (45) from inner frame (46).
(q)
Remove 12 screws (47) and lockwashers (48) and remove PTO and clutch assembly (49).
(r)
Remove eight screws (50) and lockwashers (51) and remove drive ring (52).
4-84
