TM 5-4310-386-14
4-43. Wiring Harness (Cont).
b. Replace. (figure 4-54)
(1)
Loosen nut (1) and remove negative cable (2) and black wire (3).
(2)
Tag and remove wiring harness (4) from control panel (5), starter (6), alternator (7), shutdown device
(8), pressure switch (9), interfilter block assembly (10), and 4th state valve head (11).
(3)
Inspect wiring on back of control panel (5). Refer to Appendix F for procedures to manufacture control
panel wiring.
(4)
Install wiring harness (4) as tagged to 4th stage valve head (11), interfilter block assembly (10),
pressure switch (9), shutdown device (8), alternator (7), starter (6), and control panel (5).
(5)
Install black wire (3) and negative cable (2) and tighten nut (1).
c. Repair.
(1)
Inspect wiring harness.
(2)
Replace any terminal lugs or connectors that are missing or damaged.
(3)
Replace any wire that has burnt, cracked, or otherwise damaged insulation.
4-134
