TM 5-4310-386-14
5-19. Oil Water Separator Housing.
This task covers:
a.
Replace
b.
Repair
INITIAL SETUP
Tools
Materials/Parts (Cont)
General Mechanic's Tool Kit
Distilled Water (Item 9, Appendix E)
(NSN 5180-00-177-7033)
Equipment Condition
Materials/Parts
Compressor unit shut down (para. 2-13).
Oil Water Separator Housing
Battery removed (para. 4-45).
Petroleum Jelly (Item 28, Appendix E)
Interfilter heater block assembly removed (para.5-15).
Preformed Packing
Tape (Item 25, Appendix E)
Reference
Bands, Rubber (Item 4, Appendix E)
Bags, Plastic (Item 3, Appendix E)
Cleaning Procedures, Chapter 4, Section VII.
Detergent, Nonionic (Item 8, Appendix E)
Refer to Appendix F for torque values.
a.
Replace. (figure 5-26)
WARNING
Cleanliness is imperative in maintaining and handling diving system components. All tools and
parts must be kept free of oil, grease, rust, or other contamination in accordance with Chapter 4,
Section VII of this manual. Foreign substances within an assembly could result in equipment
failure and possible injury or death to personnel.
Ensure that all air lines and components removed or openings into the air system that provides
breathing air are covered with a plastic bag and secured with a rubber band or taped shut. Small
components should be stored in a plastic bag and sealed. Failure to do so will cause air system
to become contaminated and could result in injury or death to the diver.
(1)
Remove safety valve (1) and seal ring (2) from housing (3).
(2)
Remove four screws (4) securing oil water separator housing (3) to heater block (5).
(3)
Remove oil water separator housing (3), and remove and discard one preformed packing (6).
(4)
Apply petroleum jelly to preformed packing (6).
(5)
Install preformed packing (6) and oil water separator housing (3) and secure with four screws (4).
(6)
Install safety valve (1) and seal ring (2) on housing (3).
FOLLOW-ON MAINTENANCE
(1) Install interfilter heater block assembly (para. 5-15).
(2) Install battery (para. 4-45).
5-84
