TM 5-4310-386-14c.TighteningHeavy-DutyBolts(ScrewsandNuts)onDeutzEngine.(1)Wet threads and seatings with motor oil before fitting. Do not use molybdenum disulphide products.(2)Screw bolts in initially until they are squarely seated, using a socket wrench without T-Bar and tightenwithout using any leverages shown.(3)Preload the bolts using socket wrench with T-Bar. Hold the T-Bar in such a manner that both hands are incontact with the socket shaft as shown below. Without repositioning hands, turn T-Bar until tight. When using a box endor open-end wrench for preloading, the tip of your straight thumb holding the wrench must touch the head of the bolt ornut.(4)Tightening the bolts or nuts is accomplished by extending the T-Bar and holding as shown. Tighten inaccordance with table F-2.F-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
